How much does it cost to fix a pothole? Potholes that are repaired by Goshen Asphalt can vary. Most people hire contractors to get the job done in Goshen, IN, but you can also do it yourself for just about the same amount of money.
How do you repair a pothole? Potholes can be made from trees, rocks, and other things. However, you can fix this by just using a few tools that you can buy from your local home center. You should start by grabbing a shovel and taking some of the material out of the pothole to see what is inside of it. What you find inside can give you clues to what might have caused the pothole in the first place. You don’t want to use the old material that you found inside of the hole. Instead, you want to use paver base to fill the hole. Before you do that, compact the bottom of the hole to make sure that nothing is going to settle.
Take the base, and spread it out and make it about an inch or so thick. Use one bag at a time, as compaction is a major component of a successful pothole repair. What you will use for your top coat is a cold patch asphalt repair. Then, you pour it in the hole an inch and half thick, and compact it down to one inch and build it up in layers. However, you should make sure the edges of the hole are clean and not jagged. Pour the asphalt in the middle and spread it out evenly with your shovel. Make sure that it is nice and flat. At this point, it is safe to walk and drive on, but it is not safe enough to make turns on it yet. Don’t make turns on it until about 3 or 4 weeks after it hardens up.
How do you fix a pothole in your driveway? By Calling Goshen Asphalt located in Goshen, Indiana. If your more of a DIY kinda person, the first step is to clean the area where you’re going to repair the pothole. Once you’ve cleaned the area, the next thing you want to do is get a push broom and just brush away any excess water that might still be in the hole. It is fine if the hole is damp, you just don’t want there to be any water in there. You also don’t want any weeds in the hole either. If you have weeds, remove them before continuing to the next step. A good product for this repair would be Henry Pothole Patch. This product is best because it does not require mixing, it is easy to use, and it is permanent.
The next thing you want to do turn the container of the asphalt mix over and empty it out onto the pothole. Each container will fill a 2-inch depth at a time. If it is deeper than two inches, add more layers as you go. Use a tool to spread the mix out evenly and have it about an inch and half above a final surface. After that, you can use a tamper or any flat tool to start compressing it. Next, use some crack repair and spread it along the edges of the hole, blending it with the rest of the mixture. This takes about 24 hours to dry. After that, seal it with a top coat to make it more appealing.
What do you use to fill a pothole? Goshen Asphalt uses a quality asphalt mixture such as Henry Pothole Patch or any other mix that you can find at a home store near you. You can also use concrete to fill the potholes. Filling a pothole with hot asphalt will give you long-lasting results. It is also the strongest material in the Goshen area.